Skip to content
HSCAM
Illustrative photograph for the Steel & Metals industry — not a photo of an HSCAM installation or customer.

Solutions · Steel & Metals

Steelworks, rolling mills, and other hot, fast, continuous metal processes.

Hot metal moving fast, around the clock, with defects that show up only in the next process step. This is the industry HSCAM’s STREAMER platform was proven in.

Proven deployment

Based on a real HSCAM deployment in this industry.

The problem, in this industry

Problems HSCAM has already solved in production

Each of these is a real, demonstrated HSCAM capability — shown here at the pattern level, with a link to where it was actually proven.

A continuous process, watched around the clock

The process never stops, so there is no good moment to point a camera at it — every cut, cycle or pass has to be caught, not just the ones you happen to be watching for.

STREAMER cameras stream continuously over standard USB 3.0. In-camera compression of about 5:1 reduces one camera’s ~1.44 GB/s to ~300 MB/s, which allows direct recording to a suitably specified SSD.

See it demonstrated

A fault found hours or days later, traced back to the moment it happened

The defect surfaces downstream — in quality control, in the next process step, or in a customer complaint — long after the event itself. By then the moment is gone unless it was recorded.

In the steel-mill installation a week or more of recordings was kept and reviewable in slow motion (triggered recording, 20–200 TB of storage), so a defect found later could be traced back to the cut that caused it.

See it demonstrated

Size, speed, acceleration — measured, not estimated

Knowing a workpiece moved "too fast" or "out of tolerance" isn’t enough — the measurement has to be tied to the exact video frame it happened on, or it can’t be trusted.

Image and measurement data are captured on the same camera clock, so a workpiece’s position, speed or acceleration lines up with the video frame it belongs to.

See it demonstrated
See every capability, across every industry

The evidence behind this page

Wire speed
up to 140 m/s
Wire temperature
~1,200 °C
Recordings on the page
3,000 · 4,041 · 10,702 fps
Recordings kept
≥ 1 week · 20–200 TB · triggered recording

Documented rolling-mill installation with HSCAM STREAMER 1M13.

See the full application

What helps us scope a request in this industry

  • Material speed and temperature at the point you need to see
  • How long recordings have to stay reviewable
  • How close the camera and lighting can be mounted, and what protection they need
  • Which plant signals have to be recorded alongside the video

Recognize this problem in your own process?

Talk to an engineer about steel & metals

Tell us your process, your speed, and what you need to see or measure.

Helpful, but not required

  • What your process does and what goes wrong, or what you cannot see today
  • Speed or cycle time, if you know it
  • Measurement or trigger signals that exist on the machine
  • Environment: temperature, lighting, mounting space
HSCAM GmbH · Angerstraße 40–42, Haus B · 04177 Leipzig, Germany
contact@hscam.com · hscam.com

* Required

Frame rate and image area still unknown? Just describe the sequence – we help with the design.

Your details are sent to HSCAM to answer this enquiry only — see our privacy notice, which also covers the Cloudflare spam check below. If you arrived through a campaign link, its utm_ parameters and the page you are on are sent with your enquiry.

Sent straight to contact@hscam.com.